Table of Contents
Advertisement
SCP-FRE765-041-03H
I
NSTALLATION AND
Mounting
The FRE-765 mounts on a pole or a wall. Follow local practices to ensure a secure mounting. Mount the FRE-765
for easy access to the cable entry points on the bottom of the enclosure. Provide ample room to open the door
completely.
For pole mounting the FRE-765, use the Pole Mounting kit, part number FMK 2397 List 1. Follow the instructions
that are included to install the pole mounting bracket. Then mount the FRE-765 to the bracket. Do not install any
cabling until the FRE-765 is securely mounted.
When required, install the grommet into the base of the FRE-765 (see
7) prior to performing any wiring.
can install through the holes in the grommet):
1
Select only one concentric knockout hole on the FRE-765.
2
Remove the largest knockout so that the entire hole is open.
3
Install the grommet from the outside of the FRE-765. (Hint - Hold it at an angle to the hole and roll it into
position.)
4
Ensure that the lip of the grommet rests on the bottom of the FRE-765 around the knockout hole.
5
Use an appropriate tool to open the required hole(s) in the bottom of the grommet.
For this grommet hole size
.410 to .765 in. diameter (two)
.240 to .275 in. diameter (one)
.155 to .240 in. diameter (one)
(*) Recommend using one hole for both the HDSL and the bypass pairs (i.e., 6-pair cable) and using the second hole for POTS (subscriber)
lines.
(†) Dependent upon gauge of wire used.
FRE-765 List 4A
T
EST
Table 7, "Grommet Hole Diameters," on page 7
FRE-765 enclosure
(bottom view)
Grommet
Figure 2. Installing the Grommet
Table 7.
Grommet Hole Diameters
Use this cable
• 24 or 26 AWG, 25- or 50-pair Primary Interexchange Carrier (PIC) (filled or non-filled)
*
• 22 AWG, 25-pair PIC (filled or non-filled)
• 22, 24, or 26 AWG, 6- or 11-pair PIC (filled or non-filled)
†
ground wire
ground wire
January 6, 2003
Figure 2, "Installing the Grommet," on page
shows the wire gauges that you
Grommet lip
Functional Description
7
Advertisement
Table of Contents
