ADC HiGain HRU-402 Manual page 29

150-402-111-02
system to an ASCII terminal or a PC running a terminal emulation program.
To connect a terminal emulator:
1 Connect a standard, 9-pin, serial terminal cable to the Craft port
(RS-232 DB-9 connector) on the HRU-402.
HRU-402 DB-9, and two types (DB-9 and DB-25) of RS-232 I/O
interfaces on the maintenance terminals (PCs).
2 Once the serial cable is connected to the Craft port (RS-232 DB-9
connector) on the HRU-402, connect the other end of the cable to the
9-pin or 25-pin COM port (RS-232) of the maintenance terminal
(Figure 8 on page
Terminal Equipment (DTE).
Figure 8. Connecting the HRU-402 to a Maintenance Terminal
3 Configure the maintenance terminal to the following communication
settings:
•
1200 to 9600 baud (9600 baud is recommended)
HRU-402 List 1A
21). The maintenance terminal is configured as Data
December 8, 1998
Provisioning the HRU-402
Figure 7 shows the
21