Chapter 4 Setup; Installing The Slm - THORLABS EXULUS-HD1 User Manual

EXULUS-HD1 & EXULUS-4K1 Spatial Light Modulators
Setup
Chapter 4
4.1.

Installing the SLM

High voltage inside. To avoid electrical shock, before powering up, make sure that the ground pin of
the power cord is correctly connected to the ground connector in the power socket. Improper
grounding can cause electric shock resulting in severe injury or even death. Do not operate without
Transportation and delivery may cause the SLM to be warm or cool upon receipt. Please wait for the
whole device to reach room temperature before attempting to operate.
Do not operate in wet/damp conditions. Do not obstruct the air ventilation slots in the housing!
To operate your SLM properly, place it on your lab table. There are four rubber feet on the bottom of the device to
prevent sliding. Also two tapped holes are reserved for the mounting from the bottom, as shown in Figure 13.
Rev I, October 18, 2022
SHOCK WARNING
the cover installed.
This unit must not be operated in explosive environments.
Figure 13 Post Mounting the SLM with Thorlabs' Ø1/2" Posts
WARNING
WARNING
WARNING
Chapter 4: Setup
Page 9