Table of Contents
Advertisement
STIMULATION AND TREATMENT
IF YOU SELECTED SENSORY OR MOTOR ON THE CHOOSE TREATMENT SCREEN:
1. Turn the Stim Output knob located on the left side of
the generator clockwise to increase voltage.
2. Tap Log to record the value in the procedure record.
The bar value will remain on the screen.
IF YOU SELECTED LESION ON THE CHOOSE TREATMENT SCREEN:
1. Tap Lesion, Pulsed or Dosed at the top of the screen to choose your treatment mode.
2. For Lesion and Pulsed modes, tap Manual or Auto to
start the procedure.
• For a manual procedure, use the RF Output knob
located on the right side of the generator.
*NOTE:
Pressing the red "Emergency Stop" button on the generator's front panel will require
a reboot of the machine.
3. Turn the Stim Output knob back to its starting position
and repeat for any additional sites.
3. For Dosed mode, tap Auto to start the procedure.
4. To stop before the procedure is complete, tap Stop on
the screen* at any time.
This document is a guide. For complete details, always refer to the NT2000iX
RF Generator Operator's Manual.
7
™
Advertisement
Table of Contents
