Mode Control - Hamamatsu Photonics C7557-01 Instruction Manual

C7557-01 DLL INSTRUCTION MANUAL

5-17 MODE CONTROL

Controls the mode of the sensor head. The return values are 1 with normal completion, and
other than 1 with an error. The mode of the sensor head status may be obtained as the
return value for the function.
 Function name
WORD SetModeSelect (ID, ModeSelect);
WORD GetModeSelect (ID);
 Format
WORD SetModeSelect (WORD, WORD);
WORD GetModeSelect (WORD);
 Arguments
ID
ModeSelect
(NOTE ) Be sure to make the following settings.
 Return code
For mode control
Same as for CheckSensor function
Status acquisition
22
USB ID number
Specify MCD controller USB ID number
Set mode of the sensor head (CCD)
Area Scanning 0
Line Binning
Set mode of the sensor head (C806x series)
High Gain
Low Gain
When using a CCD sensor head (operation mode control)
Area scanning
Line binning
When changing the operation mode, always make the settings with
the "Number of Summing Pixels Control" function as shown in the
table below.
WORD SetSummingVch (ID, SummingVch);
WORD SetSummingHch (ID, SummingHch);
Operation Mode
Area scanning
Line binning
When using an InGaAs sensor head C8060/61/62 (sensor head
amp control)
High Gain
Low Gain
Area scanning (CCD) /High Gain (C806x series)
0
Line binning (CCD) /Low Gain (C806x series)
1
HAMAMATSU PHOTONICS K.K.
1
0
1
0
1
SummingVch
1
Number of vertical pixels
0
1
SummingHch
1
1