Advertisement
Quick Links
VIS_ZS6301
CO Detector
Firmware Version : 3.5
Quick Start
S
This device is a wireless Z-Wave sensor. Inclusion and Exclusion is confirmed by hitting the program
button. Hitting the program button will wake up the device.
Please refer to the chapters below for detailed information about all aspects of the products usage.
What is Z-Wave?
This device is equipped with wireless communication complying to the Z-Wave standard. Z-Wave is the
international standard for wireless communication in smart homes and buildings. It is using the
frequency of 868.42 MHz to realize a very stable and secure communication. Each message is reconfirmed
(two-way communication) and every mains powered node can act as a repeater for other nodes (meshed
network) in case the receiver is not in direct wireless range of the transmitter.
Z-Wave differentiates between Controllers and Slaves. Slaves are either sensors (S) transmitting metered or
measured data or actuators (A) capable to execute an action. Controllers are either static mains powered
controllers (C) also referred to as gateways or mobile battery operated remote controls (R). This results in a
number of possible communication patterns within a Z-Wave network that are partly or completely supported
by a specific device.
1. Controllers control actuators
2. Actuators report change of status back to controller
3. Sensors report change of status of measured values to controller
4. Sensors directly control actuators
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 1
Advertisement
Related Manuals for Vision VIS ZS6301
Summary of Contents for Vision VIS ZS6301
- Page 1 VIS_ZS6301 CO Detector Firmware Version : 3.5 Quick Start This device is a wireless Z-Wave sensor. Inclusion and Exclusion is confirmed by hitting the program button. Hitting the program button will wake up the device. Please refer to the chapters below for detailed information about all aspects of the products usage. What is Z-Wave? This device is equipped with wireless communication complying to the Z-Wave standard.
-
Page 2: Product Description
5. Actuators control other actuators 6. Remote controls send signals to static controllers to trigger scenes or other actions 7. Remote controls control other actuators. There are two different role a controller can have. There is always one single primary controller that is managing the network and including/excluding devices. -
Page 3: Behavior Within The Z-Wave Network
1. Remove the bracket from the detector by rotating it counter-clockwise. 2. Place the bracket where you are going to install the detector. In each of keyhole slots, draw a mark to locate plastic anchor and screw. Using a 3/16-inch (5mm) drill bit, drills two holes at the marks and insert plastic anchor, and attached the bracket by using the screws. -
Page 4: Wakeup Intervals - How To Communicate With The Device
Power-on Mode: 1) Install the battery into the module 2) The detector will emit a beep in 0.5 seconds and the three LEDs will flash once quickly. 3) Close the bracket. The CO detector will alarm once remove the bracket. Stand-by Mode: The Green LED flashes one time every 60 seconds. -
Page 5: Node Information Frame
between maximal battery life time and the desired responses of the device. Hitting the program button will wake up the device. It is possible to set the node ID to 255 to send wakeup notifications as broadcast. In this mode device takes more time to go to sleep and drains battery faster, but can notify all it's direct neighbors about a wakeup. -
Page 6: Technical Data
Technical Data Battery Type 3 * CR123A Explorer Frame Support Yes 4.54.00 Device Type Slave with routing capabilities Generic Device Class Alarm Sensor Specific Device Class Routing Smoke Sensor Routing FLiRS Firmware Version Explanation of Z-Wave specific terms Controller — is a Z-Wave device with capabilities to manage the network. Controllers are typically Gateways, Remote Controls or battery operated wall controllers.