Download Print this page

Product Description - Vision VIS ZS6301 Quick Start Manual

Co detector

Advertisement

5. Actuators control other actuators
6. Remote controls send signals to static controllers to trigger scenes or other actions
7. Remote controls control other actuators.
There are two different role a controller can have. There is always one single primary controller that is managing the
network and including/excluding devices. The controller may have other functions - like control buttons - as well. All other
controllers don't manage the network itself but can control other devices. They are called secondary controllers. The
image also shows that its not possible to operate a sensor just from a remote control. Sensors only communicate with
static controllers.

Product description

Carbon Monoxide (CO) is a tasteless, invisible but very poisonous gas created among others by incomplete
burning of burnable material or gas. This device is measuring the CO concentration in the air and issues an
alarm when a certain level of CO is exceeded. The device will send an alarm when one of the following
conditions are met:
50 ppm for 60 minutes
100 ppm for 10 minute
300 ppm for 3 minutés
Additionally a remote device can be switched. This can be an actuator e.g. opening a door or another alarm
device such a siren. The device consists of a mounting base that is screwed to the wall and the actual
device is mounted to this base. It is recommended to place the CO sensor on the sealing because CO is
lighter than air and will always move upwards. The device is battery-operated and therefore in sleeping
mode unless an action is detected. After a programmable sleeping time the device wakes up and sends a
status information. After this the unit goes back to sleeping modus. Batteries can be changed without
unscrewing the mounting base. The unit has tree colored LED to give visual warning when the battery is low
or a CO alarm occurred.
Batteries
The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the
same device. Used batteries contain hazardous substances and should not be disposed of with household
waste!
Battery Type: 3 * CR123A
Installation Guidelines
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 2

Advertisement

loading