Page 1
VIS_ZP3102 Z-Wave Motion Detector Firmware Version : 4.84 Quick Start This device is a wireless Z-Wave actor. A single click on the programming switch on the back side of the enclosure (behind little hole) will confirm Inclusion and Exclusion. Opening the enclosure will wake up the device and keep it awake.
Page 2
3. Using the adhesive tape to mount the device about 2 m above surface. To enhance operation place the device on a position which can detect the room widely. See figure below. The solid areas are the areas monitored. Behavior within the Z-Wave network On factory default the device does not belong to any Z-Wave network.
Page 3
Operating the device The Motion detector will send a wireless signal every time a motion is detected. Please be aware that the device will need some time to adjust after turning on. After power on and inclusion please waitfor 5 minute before expecting correct operation.
Page 4
Association Groups: 1 Control Device when Motion is detected (max. nodes in group: 5) Configuration Parameters Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user needs or unlock further enhanced features. IMPORTANT: Controllers may only allow to configure signed values.