Download Print this page

Behavior Within The Z-Wave Network; Operating The Device - Vision VIS ZS6301 Quick Start Manual

Co detector

1. Remove the bracket from the detector by rotating it counter-clockwise.

2. Place the bracket where you are going to install the detector. In each of keyhole slots, draw a mark to

locate plastic anchor and screw. Using a 3/16-inch (5mm) drill bit, drills two holes at the marks and

insert plastic anchor, and attached the bracket by using the screws.

3. Open the battery cover to insert the batteries, and then replace the cover. Fix the detector with

bracket by rotating it clockwise.

Please follow the recommendations about amount and position of the sensor in your home as given above.

Avoid to place the sensor into the angle of walls, prefer positions in the middle of the room.

Behavior within the Z-Wave network

On factory default the device does not belong to any Z-Wave network. The device needs to join an

existing wireless network to communicate with the devices of this network. This process is called Inclusion.

Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the

primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion

mode. Please refer to your primary controllers manual on how to turn your controller into inclusion or

exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave

the network. Leaving the network - i.e. being excluded - sets the device back to factory default.

If the device already belongs to a network, follow the exclusion process before including it in your network.

Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to

be reset first.

Inclusion and Exclusion is confirmed by hitting the program button.

Table of Contents