Z-Wave Command Classes: Introduction COMMAND_CLASS_ASSOCIATION_GRP_INFO Thanks for choosing the Vision’s wireless PIR motion sensor of the home security device. COMMAND_CLASS_ASSOCIATION_V2 This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking COMMAND_CLASS_BASIC technology) and is fully compatible with any Z-Wave enabled network and it’s security...
Awake Mode: It will be triggering after opening the front cover (refer Table 2), also the red LED will keep on lasting 10 seconds and ZP3102 will send “Wake Up Notification” after 10 seconds. Auto Wake Up: Use “Wake Up” command to set up the awaking time (from 10 minutes to 1 week) and send the wake up notification to controller 6..
Page 4
Vision will replace it free of charge. Vision does not issue any refunds. This warnnty is extended to the original end user purchase only and is not transferable. This warranty does not apply to : (1) damage to units caused by accident, dropping or abuse in handling, or any negligent use;...
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired...
This manual is also suitable for:
Zp3102in-5Zp3102ru-5Zp3102us-5Zp3102eu-5Zp3102il-5Zp3102kr-5...
Show all
Need help?
Do you have a question about the ZP3102MY-5 and is the answer not in the manual?
Questions and answers