Advertisement
or 133MHz FSB frequency can be selected with this jumper. The over specification operation is not
recommended.
2.2 Installation of CPU
Before installing CPU, make sure the power is off. Locate the level bar on the PGA370 ZIF socket.
Push level bar away from the socket and pull upward 90 degrees. Insert the CPU into the socket.
Make sure the notch of the CPU corresponds with the white dot on the ZIF socket (the corner
without pin socket). Do not push in the CPU. Make sure all pins are aligned with the CPU socket. ON
the level bar.
Please plug in the fan cable to the three pin fan connector on the motherboard (CPUFAN).
2.3 Installation of Memory
The motherboard has 3x168-pin 64-bit Dual Inline Memory Module(DIMM)sockets divided into 3
banks.
You
DRAM(SDRAM)memory. This will increase the system reliability. You must set DRAM Clock as
66MHz from BIOS Setup if EDO RAM was installed on board.
2.3.1 Installation of 168-pin DIMM (Dual Inline Memory Module)
1. Before inserting the DIMM, make sure the pin1 of the DIMM matches with the pin1 on the DIMM socket.
2. Insert DIMM into the DIMM sockets at a 90-degree angle and press down.
2.3.2 Removal of 168-pin DIMM
1. Press the holding clips on both sides of the socket outward to release the DIMM.
2. Gently pull the DIMM out of the socket.
2.3.3 Memory Configuration
There is no jumper setting required for the memory size or type. It is automatically detected by the
system BIOS, and the total memory size is to add them together.
DIMM Socket
DIMM1
DIMM2
can
install
3.3V
Extended
EDO/SDRAM 8, 16, 32, 64, 128, 256, 512MB
EDO/SDRAM 8, 16, 32, 64, 128, 256, 512MB
Data
Output(EDO)or
DIMM Modules
Unbuffered
Synchronous
Advertisement
