Advertisement
Select address and interrupt for the Parallel port.
3.7.11 Parallel Port Mode
Select an operating mode for the parallel port. Mode options are SPP, EPP1.7, EPP1.9, ECP,
ECPEPP1.7 and ECPEPP1.9.
3.7.12 ECP Mode Use DMA
Select a DMA channel if parallel port is set as ECP, ECPEPP1.7 orr ECPEPP1.9.
3.7.13 OnChip USB
If your system contains a Universal Serial Bus controller and you have a USB peripheral, select
Enabled. The next option will become available.
3.7.14 USB Keyboard Support
This item lets you enable or disable the USB keyboard driver within the onboard BIOS.
3.8 Load BIOS Defaults
This loads the standard BIOS default values. To select, highlight it and press the<Enter> key. Then
press the <Y> and <Enter> keys to confirm. Otherwise, press the <N> key to cancel.
3.9 Load Setup Defaults
This feature loads the setup default values from BIOS default table. To select, highlight it and press
the<Enter> key. Then press the <Y> and <Enter> keys to confirm. Otherwise, press the<N> key to
cancel.
3.10 Supervisor/User Password
You can assign, modify, or cancel password settings. To modify, highlight "Supervisor Password" or
"User Password" and press the <Enter> key. The screen will prompt you ("Enter Password:"). Enter
your password. The maximum size of the password is 8 characters. System will prompt you to
reenter the password to verify. Remember the passwords are case sensitive.
If you want to remove the passwords, either delete passwords or press <Enter> when prompting for
new password.
If you want it to require password upon initial system startup and upon entering the CMOS Setup
Utility, you will need to change the selection of the (Security Option) under (BIOS FEATURES
SETUP) to "System".
If the setting is "Setup", the system will only require the password you activate CMOS Setup Utility.
3.11 IDE HDD Auto Detection
If your system has an IDE hard drive, you can use this function to detect its parameters and enter
them into the "Standard CMOS Setup" automatically.
This routine only detects one set of parameters. If your hard disk is formatted using different
parameters than those detected, you have to enter the parameters manually. If the parameters listed
do not match the ones used to format the disk, the information on that disk will not be accessible. If
the auto-detected parameters displayed do not match those that are used for your drive, ignore
them. Type N to reject the values and enter the correct ones manually from the Standard CMOS
Setup screen.
3.12 Exit CMOS Setup Utility
Press the<F10> key to save the setup and exit. Press <ESC> key to exit without saving. Either
saving or not saving modifications, screen will prompt user to confirm, and system will reboot on
exit.
Chapter 4. AGP & IDE Driver Installation
Please refer to the readme.txt file that in \VIA\4IN1DRV directory in the CD Driver Disk first then
follow the instruction to setup AGP & IDE driver.
Advertisement
