Advertisement
3.5.1 ACPI Function
This item allows you to enable or disable the function of Advanced
Configuration and Power Interface which offers improved power management when ATX power
supply is installed. Please disable this function if your power supply is AT type.
3.5.2 Power Management
Min Saving
Max Saving
User Define
3.5.3 PM Control by APM
Select "Yes" if your system has Advanced Power Management (APM).
3.5.4 Video Off After
This option allows your monitor to blank after your system went into Doze or Suspend mode. You
can elect to not blank screen by select " NA". Default value is " Suspend ".
3.5.5 Video Off Method
This field defines the video off features. The following options are available: DPMS Support, Blank
Screen, V/H SYNC + Blank . The DPMS (Display Power Management System) features allow the BIOS
to control the video display card if it supports the DPMS feature.
3.5.6 MODEM Use IRQ
This item tells the Power Management BIOS which IRQ is assigned to the installed MODEM. Option
are NA, 3, 4, 5, 7, 9, 10 and 11.
3.5.7 Soft-Off by PWRBTN
When set to "Delay 4 Sec.", the power button has a dual function where pressing less than 4
seconds will place the system in sleep mode and shut down the system when the button is held
more than 4 seconds. "Instant-Off", the system will be shut down right away when the power button
is pressed.
3.5.8 HDD Power Down
This instructs hard drives to shut off while in the Power Management modes.
3.5.9 Doze Mode
When system is inactive after the predefined time limit, system performance will drop down. This is
the first level of Power Management.
3.5.10 Suspend Mode
System further shuts down all devices except for CPU itself. This is the third level of Power
Management.
3.5.11 VGA
When set to On, any event occurring at a VGA port will awaken a system which has been powered
down.
3.5.12 LPT & COM
When set to On, any event occurring at a LPT (printer) / COM (serial) port will awaken a system
which has been powered down.
3.5.13 HDD & FDD
When set to On, any event occurring at a Hard Disk or floppy drive port will awaken a system which
has been powered down.
System starts power saving function when the inactivity period
exceeds 1 hour.
System starts power saving function when the inactivity period
exceeds 1 min.
Allows user to define the inactivity period before power saving
function activates,
Advertisement
