Table of Contents
Advertisement
Using the remote control
Operational range of the remote control
Front of projector
30°
30°
Operate the remote
control within a distance
of 10 m from the projector,
pointing the light beam at
the remote control photo-
sensor (front or rear) of
the projector.
When operating the remote control, keep the
distance from the remote control to the projector
via the screen within about 7 m. The operable
range of the remote control, however, depends
on the characteristics of the screen.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operation area.
• When the remote control is connected with remote control cable, it does not function as a wireless remote control.
• When using the wired remote control, the laser beam may be darker. It is normal.
• When REMOTE OUT terminal on
this projector is connected to the
REMOTE IN terminal on the other
projector, the two projectors can
be controlled together by using
the remote control. (Up to two
projectors can be controlled.)
• Keep the remote control photo-sensor out of direct
Rear of projector
• Keep the remote control photo-sensor at least 2 m
• If there is an inverter-operated fl uorescent lamp
30°
30°
• When you use the remote control too close to the
20°
5°
20°
20°
sunlight or fl uorescent lamp light.
away from fl uorescent lamps. Otherwise, the remote
control may malfunction.
near the remote control, the remote control opera-
tion may become unstable.
remote control sensor, the remote control may not
work correctly.
20°
5°
20°
20°
REMOTE IN
REMOTE OUT
EN-9
Advertisement
Table of Contents
