Table of Contents
Advertisement
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Press <MENU> repeatedly until diM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to set the dimmer curve, from oFF to diM1–3, with diM1 as the fastest
and diM3 as the slowest.
4.
Press <ENTER>.
Factory Reset
To reset the COREpar UV120 ILS to default factory settings, follow the instructions below:
1. Press <MENU> repeatedly until SEt shows on the display. Press <ENTER>.
2. Use <UP> or <DOWN> to select rESt. Press <ENTER>.
3. Use <UP> or <DOWN> to select yes (resets product to factory default) or no (keep current settings).
4.
Press <ENTER>.
Temperature
To view the current temperature of the COREpar UV120 ILS, follow the instructions below:
1. Press <MENU> repeatedly until Temp shows on the display.
2. Press <ENTER>.
IRC-6 Infrared Remote Control
The COREpar UV120 ILS can be operated with the CHAUVET IRC-6. To enable IR wireless control, follow
the instructions below.
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Press <UP> repeatedly until ir shows on the display.
4. Press <ENTER>.
5. Press <UP> repeatedly until on shows on the display.
6. Press <ENTER>.
IRC-6 Operation
Automatic Mode
To turn on Automatic mode with the IRC-6:
BLACK
AUTO
SOUND
OUT
Sound-Active Mode
To turn on Sound-Active mode with the IRC-6:
SENSI-
STROBE
SPEED
TIVITY
To adjust the sound sensitivity:
%
MANUAL
FADE
R
G
B
Strobe
A
UV
W
To adjust the strobe with the IRC-6:
-
+
0
1
2
3
Brightness
To adjust the LED brightness with the IRC-6:
4
5
6
7
8
9
Black Out
To black out the lasers with the IRC-6:
This will turn off all the lasers until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
•
Any setting on the IRC-6 will be saved until the system is rebooted. The system will
revert to Auto Mode after reboot.
•
The buttons on the IRC-6 not listed above are reserved for future use.
Page 11 of 15
1. Press <AUTO> on the IRC-6.
1. Press <SOUND> on the IRC-6.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
1. Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the speed of the strobe.
1. Press <%> on the IRC-6..
2. Press <+> or <–> to increase or decrease the brightness of the output.
1. Press <BLACK OUT> on the IRC-6.
COREpar UV120 ILS User Manual Rev. 1
Operation
Advertisement
Table of Contents
