Table of Contents
Advertisement
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
Preset Color Mode
To run the EZLink Strip Q6BT ILS on a static color, follow the instructions below:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select a static color, from C 1–15.
4. Press <ENTER>.
Automatic Programs
To run the EZLink Strip Q6BT ILS in automatic mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select an automatic program, from P 1–8.
4. Press <ENTER>.
Auto-Program Speed
To change the auto-program speed on the EZLink Strip Q6BT ILS , do the following:
1. Press <MENU> repeatedly until S-- shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the program speed, from S. 1–100.
3. Press <ENTER>. The product will return to the last selected mode.
Dimmer
To set the dimmer curve, follow the instructions below:
1. Press <MENU> repeatedly until d-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the dimmer, from L. 1–255.
4. Press <ENTER>.
Sound-Active Programs
To run the EZLink Strip Q6BT ILS with a sound-active program, follow the instructions below.
1. Press <MENU> repeatedly until Snd shows on the display.
2. Use <UP> or <DOWN> to set the Sound-Active program, from Snd1 to Snd8.
3. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity on the EZLink Strip Q6BT ILS , do the following:
1. Press <MENU> repeatedly until SEnS shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from u 0–100.
3. Press <ENTER>.
Custom Color Mixing
To custom mix a static color, do the following:
1. Press <MENU> repeatedly until u-- shows on the display.
2. Press <ENTER> and one of the following will show on display.
•
r._ _ _ (red)
•
G._ _ _ (green)
•
b._ _ _ (blue)
•
A._ _ _ (amber)
•
S._ _ _ (Strobe)
3. Press <ENTER> to cycle through the color settings.
4. When the desired color shows on the display, use <UP> or <DOWN> to increase or decrease the
color value, from 000–255 (red, green, blue, amber) or 000–100 (Strobe).
5. Repeat steps 3 and 4 until the product outputs as desired.
10
EZLink Strip Q6BT ILS User Manual Rev. 1
Operation
Advertisement
Table of Contents
