How To Set The Menus - Mitsubishi Electric FL7000LU User Manual

Menu operation (continued)

How to set the menus:

Following describe how to set AUTO POWER OFF
time.
1. Press the MENU button.
opt.
IMAGE
2. Press the or button to select a menu to use.
opt.
INSTALLATION
3. Press the ENTER button (or
opt.
INSTALLATION
LAMP MODE
Available settings in the menus
Set the following items on their relevant menus.
1. IMAGE menu
opt.
IMAGE
COLOR
ENHANCER
CONTRAST
BRIGHTNESS
COLOR TEMP. STANDARD
COLOR
TINT
SHARPNESS
ADVANCED MENU
ITEM
COLOR ENHANCER
CONTRAST
BRIGHTNESS
COLOR TEMP.
COLOR
TINT
SHARPNESS
ADVANCED MENU
NOISE REDUCTION
CTI
INPUT LEVEL
INPUT LEVEL is unavailable when the digital signal is supplied from the YC
•
device.
button).
STANDARD
IMAGE - ADVANCED menu
IMAGE
ADVANCED MENU
AUTO
NOISE REDUCTION
0
CTI
0
INPUT LEVEL
0
0
0
OK
SETTING
AUTO
PRESENTATION
STANDARD
THEATER
sRGB
USER
±30
±30
4 options
±10
±10
±5
ON / OFF
ON / OFF
±5
ENHANCED /
NORMAL
4. Press the
AUTO POWER
ON
AUTO POWER
OFF
5. Set the selected item by pressing the
AUTO POWER
ON
AUTO POWER
OFF
To cancel the menu:
6. Press the MENU button several times.
Important:
• When the MENU button doesn't function, unplug
the power cord from the wall outlet. Wait about 10
minutes, plug the power cord in, and try again.
• After selecting the items marked with
ENTER button.
opt.
ON
ON
0
FUNCTION
Select to optimize the settings automatically depending on the input
signal. (Select this option for normal use.)
Select to make the displayed image look bright and crisp.
Select to make the displayed image look natural.
This option, suitable for viewing movies, makes the displayed image look
soft and smooth.
Select to give priority to the color reproducibility.
• When COLOR ENHANCER is sRGB, COLOR TEMP., COLOR and TINT
can't be adjusted.
Select to set the gamma curve or adjust the color intensity or color
balance as desired. (See page 29.)
Use to adjust the contrast of the projected image. (See page 28.)
Use to adjust the brightness of the projected image. (See page 28.)
Use to adjust the color temperature. (See page 29.)
Use to adjust the color thickness of the projected image. (See page 28.)
• When the COMPUTER1, COMPUTER2 or DVI is selected as the input
source, COLOR can't be adjusted.
Use to adjust the color tint of the projected image. (See page 28.)
• When the COMPUTER1, COMPUTER2 or DVI is selected as the input
source, TINT can't be adjusted.
• TINT is available only when the NTSC signal is input.
Use to adjust the sharpness of the projected image. (See page 28.)
Use to reduce noise and roughness in the image when noisy video signal
is input.
Use to correct smeared color boundaries.
For analog signal input: The input level of video signal differs among
devices to be connected. High input level causes solid white in displayed
image and low input level causes displayed image to get dark. Use this
menu to adjust the input level of analog video signal.
For digital signal input: When a digital signal is input, ENHANCED and
NORMAL are switchable. (See page 19.)
EN-23
or button to select an item to adjust.
OFF
OFF
OFF
30min
C /YP P terminal of the connected
B R B R
or button.
, press the