Mitsubishi Diamond Plus 120U User Manual page 18

Group
Item
Icon
Icon
USB UP-STREAM
N O T E
USB Monitor Control will be available when installing "USB Monitor Control Software" into the computer. The "USB Monitor
Control Software" can be downloaded from Mitsubishi Internet Home Page:
http://www.mitsubishi-display.com/
Item
The USB functions of the com-
puter connected to Upstream port
ROOT-A become active.
N O T E
The Upstream port in active is colored by blue on the OSD screen.
In case that either the Upstream port ROOT-A or ROOT-B is
chosen by this function, the auto-change of the Upstream port is not
available.
It may take about 15 seconds until the USB devices have been
recognized by the computer after the Upstream port is changed.
The Upstream port ROOT-A is
assigned for signal input connec-
tor "D-SUB" and ROOT-B is as-
signed for "BNC"
N O T E
This function is to change the Upstream port automatically in
corresponding to the change of signal input connector.
USB PORT
This function is only available in case that both the Upstream ports
are connected to the computers.
COMBINATION
It may takes 15 seconds until the USB devices have been recog-
nized by the computer after the Upstream port is changed.
In case that the computer chosen enters into a power management
mode, the signal input connector and Upstream port are changed to
others automatically.
When the Upstream port which is connected to the computer not
displays on the screen is selected, the operation of the USB devices
connected to the Downstream ports is not shown on the screen of the
display monitor.
Press the Minus Button
Make sure the operation of the devices connected to the down-
stream ports before changing USB Upstream ports. It may take
approximately 15 seconds max. until the devices have been
recognized by the computer and start to operate after the Up-
stream ports are changed.
Do not change the Upstream ports during enumeration to prevent
errors of the operation of devices or application software.
Close all Windows programs before changing Upstream ports.
- 18 -
Press the Plus Button
The USB functions of the com-
puter connected to Upstream port
ROOT-B become active.
The Upstream port ROOT-A is
assigned for signal input con-
nector "BNC" and ROOT-B is
assigned for "D-SUB".