Mitsubishi Diamond Plus 120U User Manual page 13

(2) Click "Next" on Figure 11 and Figure 12 will appear.
Figure 12
(3) Click "Next" on Figure 12 and Figure 13 will appear.
Figure 13
(4) Click "CD-ROM Drive(C)" and "(L)", and click "Next".
Figure 14 will appear.
Figure 14
(5) Click "Next" on Figure 14 and Figure 15 will appear.
Click "Finish" on Figure 15 to complete Enumeration of
Mitsubishi Monitor Function.
N O T E
The following should be observed in order to use the USB function reliably:
• Make sure all connections are made firmly and correctly.
• Do not change the Upstream port during the recognition of the monitor or other peripherals.
• Close all Windows program before changing the Upstream or disconnecting USB cable.
You can confirm that Enumeration of Mitsubishi Monitor
Function is successfull with the following method.
• Open "Device Manager" tab in "System" property
under "Control Panel". Confirm that "HID-compliant
Device" and "USB Human Interface Device" are listed
in "Human Interface Device". If you can't confirm it, re-
enumerate "Mitsubishi Monitor Function" again by
following (a) or (b).
(a) Disconnect and connect the USB cable to the up-
stream port of the display monitor.
(b) Power Off/On the display monitor.
N O T E
If the mark appears with "HID-Compliant Device"
and/or "USB Human Interface Device", the enumera-
tion was unsuccessful. Select "HID-Compliant Device"
and/or "USB Human Interface Device" marked with
mark and click "Remove" and "Refresh". After
that, the enumeration is automatically started.
Generic USB Hub
- 13 -
Figure 15
Figure 16