Icom UR-FR5000 Instructions

CHANNEL EXTENSION MODULES
UR-FR5000
UR-FR6000
SUPPLIED ACCESSORIES
q DC power cable ...................................................1
w Control cable ........................................................1
e Angles ..................................................................2
r Screws (M4×8 mm) ..............................................4
t Set screws (M3×6 mm) ........................................4
y Tapping screws (M3×8 mm) .................................2
q
e r
FOR CLASS B UNINTENTIONAL RADIATORS
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
Icom, Icom Inc. and the logo are registered trademarks of Icom Incor-
porated (Japan) in the United States, the United Kingdom, Germany,
France, Spain, Russia and/or other countries.
All other products or brands are registered trademarks or trademarks of
their respective holders.
INSTRUCTIONS
1
1 mm = / inch
32
w
t y
T h a n k yo u fo r p u r c h a s i n g t h e U R - F R 5 0 0 0 /
UR-FR6000
CHANNEL EXTENSION MODULES
Please read these instructions and repeater's
instruction manual carefully before installation and
operation.
OPENING CASE
q Remove 7 screws from top and 2 screws each from
both sides of the repeater, then slide off the top cover
to the direction of the arrow as illustrated below.
P 0 P 0
w Remove 3 screws from bottom and 2 screws each
from both sides of the repeater.
e Disconnect the control cable from the channel
module (original), then remove the front panel.
Channel module Channel module
(original) (original)
Front panel Front panel
P 0 P 0
P 1 P 1
P 2 P 2
P 3 P 3
P 4 P 4
r Remove 6 screws from the front panel, then re-
move the shielding plate and rubber seal.
.
P 1 P 1
P 2 P 2
P 3 P 3
P 4 P 4
P 0 P 0
P 1 P 1
P 2 P 2
P 3 P 3
P 4 P 4
Shielding plate Shielding plate
Rubber seal Rubber seal