Advertisement
Getting Prepared
Getting Prepared
The PNA-X contains extremely sensitive components that can be ruined if
mishandled. Follow instructions carefully when making cable connections,
especially wire harness connections.
The person performing the work accepts responsibility for the full cost of
the repair or replacement of damaged components.
IMPORTANT!
—
—
—
a. See
"Downloading the Online PNA–X Service Guide" on page
To successfully install this upgrade kit, you will need the following:
— A license key - refer to
— A PDF copy or a paper copy of the PNA-X Service Guide - refer to
— An ESD-safe work area - refer to
— Correct tools - refer to
— Enough time - refer to
— Test equipment for the post-upgrade adjustments and full instrument
Installation Note N5245-90117
This document contains references to legacy A27/A28 mixer brick
assemblies. Your model instrument may have either legacy assemblies
or the new parts installed.
Your A27/A28 mixer brick might be a legacy part number 5087-7323
(with (x2) discrete 3dB attenuators 08490-60010) or new part number
5087-7417 (with integrated 3 dB attenuators).
See also your instrument's PDF Service Guide
"Downloading the Online PNA–X Service Guide"
Electrostatic Discharge"
calibration. To view the equipment list, click the Chapter 3 bookmark "Tests
and Adjustments" in the PDF Service Guide
1. See
"Downloading the Online PNA–X Service Guide" on page
9.
"License Key Redemption"
"Protecting Your Workspace from
below.
"Tools Required for the Installation" on page
"About Installing the Upgrade" on page
1
.
a
.
below.
below.
10.
10.
9.
7
Advertisement
