Deck Discharge Chute Installation; Deck Discharge Deflector Shield Installation (Side Discharge Models Only); Pto Shaft Guard Installation - Walker T27i Operator's Manual

T27i

Deck Discharge Chute Installation

(GHS Collection Models Only)
Mount the discharge chute hinge on top of the
deck discharge opening using two (2) 1/4-20 x 1/2
in. carriage bolts and 1/4-20 ESNA nuts. Position
the bolts with the heads inside the chute and the
nuts on the outside. Attach spring for tilt-up action
from chute to bracket on deck.
Carrier Frame
Tube Sockets
Discharge Chute Installation
on Collection Deck
Deck Discharge Deflector Shield Installation
(Side Discharge Models Only)
Attach the side discharge deflector shield using
two (2) 3/8-16 x 1-1/4 in. bolts, 3/8-16 ESNA nuts,
and 3/8 in. wave spring washers. The wave wash-
ers fit between the two hinging surfaces. Tighten
the nuts until the shield moves freely but is not
loose.
DO NOT operate the machine without the
grass deflector shield attached and in the
lowest possible position.
Attach
Chute
Nut on Top
WARNING
Discharge Shield Installation
on Side Discharge Deck

PTO Shaft Guard Installation

Position the shaft guard as shown and mount with
two (2) 1/4-20 x 1/2 in. bolts.
PTO Shaft Guard Installation
Assembly Instructions
Attach Shield
Attach Guard
21