Changing Engine Crankcase Oil/Oil Filter - Walker T27i Operator's Manual

Maintenance Instructions
Lubrication

Changing Engine Crankcase Oil/Oil Filter

Change the engine crankcase oil and filter every
300 hours if the recommended Kohler PRO
ucts are being used. If conventional oil and filters
are being used, change the crankcase oil after
every 100 hours of operation and replace the oil
filter after 200 hours of operation.
Park the mower on a level surface with the
1.
en gine stopped. The engine oil should be
warm before draining. If not warm from opera-
tion, start the engine and run a few minutes to
warm the oil.
2. Before removing the dipstick, clean the area
around the dipstick to keep any dirt or debris
out of the engine.
3. Remove the dipstick and the oil drain plug and
drain the oil into a suitable container. Be sure
to allow ample time for complete drainage.
Oil Drain/Oil Filter Location
4. Before removing the oil filter, clean the area
around the filter to keep dirt and debris out of
the engine.
5. Remove the old oil filter and wipe off the filter
mounting surface on the engine.
6. Apply a thin coating of clean oil to the rubber
gasket on the replacement oil filter.
IMPORTANT: Use ONLY Kohler oil filters.
See the Specifications section for a list of
recommended filters. After market oil filters
may not seal properly and/or may not have the
correct pressure relief valve for proper lubrica-
tion.
58
prod-
®
Drain Plug
Oil Filter
7. Install the new oil filter on the engine. Turn the
filter clockwise until the rubber gasket contacts
the sealing surface, then tighten an additional
3/4 to 1 turn.
8. Reinstall the drain plug. Make sure it is tight-
ened to 10 lb·ft (14 N·m).
9. Remove the fill cap on the engine valve cover,
and fill the crankcase with new, clean oil. Use
only crankcase lubricants recommended by
the engine manufacturer. Refer to Crankcase
Lubricant on page 3 in the Specifications
section of this manual or the engine owner's
manual. Use the recommended oil viscosity
for the expected ambient temperature. Oil
with the correct vis cosity will aid starting in
cold weather and assure proper lubrication in
hot weather. Fill up to, but not above, the
"F" mark on the dipstick. Crankcase capacity
is 2.0 quarts (1.9 liters) plus 1/2 pint (0.24
liters) for the new oil filter.
IMPORTANT: Check the dipstick reading
be fore adding the last 1/2 pint of oil and fill
only to the "F" mark. DO NOT overfill the
crankcase (oil above "F" mark) as this CAN
result in en gine overheating, loss of power,
and possible engine damage.
10. Start the engine and check for oil leaks around
the oil filter. Stop the engine, recheck the oil
level, and add oil if necessary. (When the
engine is first operated with a new oil filter, the
oil level drops slightly as the filter is filled with
oil.)
T27i