Deck Discharge Chute Installation; Deck Discharge Deflector Shield Installation; Pto Shaft Guard Installation - Walker D21d Operator's Manual

Assembly Instructions
3. Insert the 3/8-16 x 4-1/2 in. bolt through the
wheel fork with the bolt head to the outside and
install the 3/8-16 in. Keps nut.
4. Tighten the bolt and nut until the inner bearing
race bottoms against the inside of the wheel
fork (will not turn) while the wheel spins freely
without binding.
Axle Bolt
Deck Caster Wheel Installation
5. Grease the caster pivot bearings - one grease
fitting for each pivot.

Deck Discharge Chute Installation

(GHS Collection Models Only)
Mount the discharge chute hinge on top of the deck
discharge opening using two (2) 1/4-20 x 1/2 in. car­
riage bolts and 1/4-20 ESNA nuts. Position the bolts
with the heads inside the chute and the nuts on the
outside. Attach spring for tilt-up action from chute to
bracket on deck.
Carrier Frame
Tube Sockets
Nut on Top
Discharge Chute Installation
on Collection Deck
22
Axle Spacer Tube
Attach
Chute

Deck Discharge Deflector Shield Installation

(Side Discharge Models Only)
Attach the side discharge deflector shield using two
(2) 3/8-16 x 1-1/4 in. bolts, 3/8-16 ESNA nuts, and
3/8 in. wave spring washers. The wave washers fit
between the two hinging surfaces. Tighten the nuts
until the shield moves freely but is not loose.
WARNING
DO NOT operate the machine without the
grass deflector shield attached and in the
lowest possible position.
Discharge Shield Installation
on Side Discharge Deck

PTO Shaft Guard Installation

Position the shaft guard as shown and mount with
two (2) 1/4-20 x 1/2 in. bolts.
PTO Shaft Guard Installation
Attach Shield
Attach Guard