Deck Discharge Chute Installation; Deck Discharge Shield Installation; Pto Shaft Guard Installation; Tilt-Up Roller Wheel Installation - Walker Model MS (13 HP) Owner's Manual

Assembly Instructions
Spacer Washer
Axle Spacer Tube
Deck Caster Wheel Installation
NOTE: If semi-pneumatic wheels are installed,
make sure the spacer washers fit over the
spacer tube and are not caught between the fork
and the end of the tube. The washers should
move freely on the axle spacer tube.
5. Grease the caster wheel bearings and caster
pivot bearings - one grease fitting for each wheel
and each pivot.

Deck Discharge Chute Installation

(GHS Rear Discharge Models Only)
Mount the discharge chute hinge on top of the deck
discharge opening using the 1/4-20 x 1/2 in. socket
button head bolt and 1/4-20 ESNA nut. Position the
bolt with the head inside of the chute and the nut on
the outside.
Attach Guard
Discharge Chute and PTO Shaft Guard
Installation on Rear Discharge Deck
18
Grease Fitting
Locations
Carrier Frame
Tube Sockets
Attach
Nut on Top

Deck Discharge Shield Installation

(Side Discharge Models Only)
Attach the deck side discharge shield by positioning
the shield hinge lug in front of the deck mount and
fastening with two (2) 3/8-16 x 1-1/4 in. bolts, 3/8-16
ESNA nuts, and 3/8 in. wave spring washers. The
wave washers fit between the two hinging surfaces.
Tighten the nuts until the shield moves freely but is
not loose.
DO NOT operate the machine without the
grass deflector chute attached and in the
lowest possible position.

PTO Shaft Guard Installation

Chute
Position the shaft guard as shown and mount with two
1/4-20 x 1/2 in. bolts.

Tilt-Up Roller Wheel Installation

Mount the two (2) tilt-up roller wheels on the brackets
on the rear skirt of the deck housing using the
P/N 8490 axle bolt, 3/8 in. wave spring washer and
3/8-16 in. Whiz locknut. Tighten the axle bolt until the
wheel rolls freely, but is not loose.
WARNING
Attach Shield
Discharge Shield Installation
on Side Discharge Deck