Mounting Bars - Rifton HTS Product Manual

Mounting bars

WARNING
the toilet is securely attached to the
floor and that the seat bolts are in good
condition before attaching the mounting
bar. Inspect the toilet stability and seat
bolts at regular intervals while the
mounting bar is in use.
Figure 11a:
bars fit either standard round or elongated
toilets. To determine which type you need,
measure from the centerline of the seat
bolts to the front edge of the porcelain
bowl. Use a standard toilet mounting bar if
this is 17"(43 cm) or less, otherwise use the
elongated toilet mounting bar.
Figure 11b:
the toilet, remove the nuts (A) under the
toilet bowl rim which fasten the toilet seat
and lid to the toilet. Remove the seat and
lid. Place two of the rubber washers (B)
provided with the mounting bar over the
two holes. Place the mounting bar over
the washers with the warning label facing
up and forward. Replace the seat and lid
with the bolts (C) going through the holes
in the mounting bar, the washers, and the
holes in the toilet. Replace the nuts (A) and
tighten firmly.
Attaching seat to mounting bar
WARNING
both hooks are fully engaged in the
sockets of the mounting bar before using
the HTS.
Figure 11c:
mounting bar, move the backrest out of
the way by tilting or sliding it forward, then
insert both hooks (D) on the seat into the
sockets on the mounting bar and lower the
seat onto the toilet bowl.
11
To prevent falls or
injuries, ensure that
The two kinds of mounting
To install the mounting bar on
To prevent falls or
injuries, ensure that
To attach the seat to the
For elongated toilets
For standard toilets
and large HTS
Figure 11a
Tip: For the large HTS, only one style
of mounting bar is available.
C C
Figure 11b
D D
Figure 11c
B B
A A