Table of Contents
Advertisement
INDICATOR LED
■ STATUS INDICATOR LED
SD *
PWR
RUN
ERR
1
ON
ON
BL
BL
ON
ON
BL
BL
ON
ON
BL
BL
ON
ON
BL
OFF
ON
ON
BL
OFF
ON
ON
OFF
BL
ON
ON
OFF
BL
ON
ON
OFF
OFF
ON
ON
OFF
OFF
ON
OFF
BL
BL
ON
OFF
BL
BL
ON
OFF
BL
OFF
ON
OFF
BL
OFF
ON
OFF
OFF
BL
ON
OFF
OFF
BL
ON
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
OFF ON/OFF Faulty Baud Rate and/or Station Address setting
OFF
OFF
OFF
OFF
OFF = OFF, ON = ON, BL = Blinking
*1. SD LED may look not blinking but ON with high baud rate and fewer connected modules.
*2. LEDs indicated with "----" in STATUS rarely occurs in normal operation (LED failure or the like as possible cause).
PC CONFIGURATOR
With configurator software, settings shown below are available.
Refer to the software manual of R7CON for detailed operation.
■ INTERFACE MODULE SETTING
PARAMETER
Communication Timeout
■ CHANNEL INDIVIDUAL SETTING
PARAMETER
Zero scale
Full scale
Bias
Gain
■ EXTENSION MODULE SETTING
PARAMETER
Output Hold/Clear
SEN TRONIC
STATUS *
RD
2
ON
Communicates normally with occasional CRC errors due to noise interference.
ON
Communicates normally but the Baud Rate and/or Station Address switches failed.
ERR LED blinks approximately in 0.5 seconds intervals.
OFF
----
ON
CRC error found in the received data. Unable to respond.
OFF
----
ON
Normal communication
OFF
----
ON
Unable to receive data addressed to the station.
OFF
----
ON
Performs the interval-timed responses but CRC error found in receiving the refresh
data.
OFF
----
ON
CRC error found in the data addressed to the station.
OFF
----
ON
Link is not started.
OFF
----
ON
No data addressed to the station. Or unable to receive data addressed to the station
due to noise interference. (Missing parts of the data sent from the master)
OFF
Unable to receive data due to wire breakdown
OFF
Power input removed. Or power supply failure.
AVAILABLE RANGE
0.0 – 3276.7 (sec.)
AVAILABLE RANGE
-32000 to +32000
-32000 to +32000
-320.00 to +320.00
-3.2000 to +3.2000
AVAILABLE RANGE
Output Hold
Output Clear
056 222 38 18
AG
DEFAULT SETTING
1.0 (sec.)
DEFAULT SETTING
0
10000
0.00
1.0000
DEFAULT SETTING
Output Hold
mailbox@sentronic.com
www.sentronic.com
R7C-YS2
EM-7801-E Rev.5 P. 3 / 10
Advertisement
Table of Contents
