®
NetVanta E1/FE1 + G.703 Drop Network Interface Module (NIM)
Quick Start Guide
WAN-E1
S
PECIFICATIONS
Operating Modes E1/FE1 Frame Relay, E1/FE1 PPP
E1/FE1 Interface
Line Rate: 2.048 Mbps ±50 PPM
Line Code: AMI or HDB3
Framing: FAS with optional CRC-4
FE1 Line Rate: Timeslot, channelized (in multiples of
56/64 kbps)
Receiver Sensitivity: -30 dB
Connector: RJ-48C
G.703 Interface
Line Interface: Per ITU-T G.703
Receiver Sensitivity: -30 dB
Line Rate: 2.048 Mbps, ±50 PPM
Capacity: 1 to 31 timeslots
If timeslot 16 signaling is used on the drop port, a maximum
of 15 timeslots can be mapped to router (1 to 15 or 17 to 31).
Line Code: AMI or HDB3
Framing: FAS with Optional CRC-4
Connector: RJ-48C
Clock Source
Network, Internal, and Through
Diagnostics
Test Pattern Generation and Detection: QRSS, 511
Network loopbacks
Alarm generation and detection
Network performance data (15 minutes and 24 hours)
Standards
FCC Part 15 Class A, EN 55022 Class A, EN 55024,
EN 61000-3-2, EN 61000-3-3
ACIF S016, ETSI TBR 12/TBR 13
EN60950, AS/NZS 60950, IEC 60950
ITU G.703, ITU-T G.704 (CRC-4), ITU-T G.823,
ITU-T G.797
Physical
Dimensions: 2.75 inch W x 4.25 inch D
Operating Temperature: 0°C to 50°C
Storage Temperature: -40°C to 85°C
Relative Humidity: Up to 95 percent, noncondensing
Quick Start Guide, 61200878L1-13C, March 2005
G.703
DBU
ADTRAN Technical Support +1-256-963-8716
For more detailed documentation, visit us online at www.adtran.com.
I
I
NSTALLATION
NSTRUCTIONS
1.
Remove power from the unit.
2.
Slide the Network Interface Module (NIM) into the option slot
until the NIM is firmly seated against the front of the chassis.
3.
Secure the pins at both edges of the NIM.
4.
Connect the cables to the associated device(s).
5.
Complete the installation of the base unit.
6.
Restore power to the unit.
WAN-E1 N
ETWORK
Pin
Name
1
R1
2
T1
3
—
4
R
5
T
6-8
—
G.703 (RJ-48C) C
ONNECTION
Pin
Name
1
R
2
T
3
—
4
R1
5
T1
6-8
—
NetVanta modules should be installed only in
NetVanta Series products.
P/N 1200878L1
(RJ-48C) C
ONNECTION
Description
Receive data from the network
Receive data from the network
Unused
Transmit data toward the network
Transmit data toward the network
Unused
P
INOUT
Description
Transmit data toward the DTE
Transmit data toward the DTE
Unused
Receive data from the DTE
Receive data from the DTE
Unused
Copyright © 2005 ADTRAN, All Rights Reserved
P
INOUT