Safety Instructions; Care - tams elektronik S88-2 Manual

tams elektronik

1.4. Safety instructions

Please note:
!
The s88 booster contains integrated circuits (ICs). These are sensitive to electrostatic
charging. Therefore, do not touch these components until you have "discharged" yourself.
For this purpose, e.g. a grip on a radiator is sufficient.
Improper use and non-observance of the instructions can lead to incalculable hazards. Prevent
these dangers by carrying out the following measures:

Only use the s88 booster in closed, clean and dry rooms. Avoid moisture and splash water
in the environment. After condensation has formed, wait two hours for acclimatisation
before use.

Disconnect the s88 booster from the power supply before carrying out wiring work.

Supply the s88 booster only with extra-low voltage as specified in the technical data. Use
only tested and approved transformers.

Only plug the mains plugs of transformers into properly installed and fused earthed sockets.

When making electrical connections, ensure that the cable cross-section is sufficient.

Heating of the s88 booster during operation is normal and harmless.

Do not expose the s88 booster to high ambient temperatures or direct sunlight. Observe
the information on the maximum operating temperature in the technical data.

Regularly check the operational safety of the s88 booster, e.g. for damage to the
connection cables.

If you notice damage or if malfunctions occur, disconnect the connection to the power
supply immediately. Send the s88 booster in for inspection.

1.5. Care

Do not use any cleaning agents to clean the s88 booster. Only wipe the module dry.
Disconnect the s88 booster from the power supply before cleaning.
S88-2
Getting started | 5