Intended Use; Safety Instructions; Care - tams elektronik S88-3 Manual

tams elektronik

1.3. Intended use

The s88 feedback module is intended for use in model railway layouts as specified in the
instructions. Any other use is not in accordance with the intended use and will result in the
loss of the warranty claim. Intended use also includes reading, understanding and following all
parts of the instructions. The s88 feedback module is not intended to be used by children
under the age of 14.

1.4. Safety instructions

Note:
!
The s88 feedback module contains integrated circuits (ICs). These are sensitive to
electrostatic charging. Therefore, do not touch these components until you have
"discharged" yourself. For this purpose, e.g. a grip on a radiator is sufficient.
Improper use and non-observance of the instructions can lead to incalculable hazards. Prevent
these dangers by carrying out the following measures:

Only use the s88 feedback module in closed, clean and dry rooms. Avoid moisture and
splash water in the environment. After condensation has formed, wait two hours for
acclimatisation before use.

Disconnect the module from the power supply before carrying out wiring work.

Supply the s88 feedback module only with extra-low voltage as specified in the technical
data. Use only tested and approved transformers.

Only plug the mains plugs of transformers into properly installed and fused earthed sockets.

When making electrical connections, ensure that the cable cross-section is sufficient.

Heating of the s88 feedback module during operation is normal and harmless.

Do not expose the s88 feedback module to high ambient temperatures or direct sunlight.
Observe the information on the maximum operating temperature in the technical data.

Regularly check the operational safety of the s88 feedback module, e.g. for damage to the
connection cables.

If you notice damage or if malfunctions occur, disconnect the connection to the power
supply immediately. Send the s88 feedback module in for inspection.

1.5. Care

Do not use any cleaning agents to clean the s88 feedback module. Only wipe the module dry.
Disconnect the module from the power supply before cleaning.
S88-3
Getting started | 5