Order Data - GEM 1434 mPos Operating Instructions Manual

6 Order data

6 Order data
The order data provide an overview of standard configurations.
Please check the availability before ordering. Other configurations available on request.
Note: Pneumatic connecting components (union and compressed air tube) for the connection between the process valve and
positioner are included with each positioner with a pneumatic connection (7) code 2 and 3.
Note: A valve specific mounting kit is required for assembly. For designing the mounting kit, the valve type, nominal size, control
function and actuator size must be stated.
Order codes
1 Type
Electro-pneumatic positioner
µPos
2 Fieldbus
Without (3-wire version)
3 Accessory
Accessory
4 Action
Single acting
5 Set value input
4–20 mA, set value specification
0–20 mA, set value specification
0–10 V, set value specification
6 Accessory housing material
Stainless steel base, PP cover
3.2315,
AlMgSi1/AlSi1MgMn
7 Pneumatic connection
Air supply M5 connection thread,
outlet M5 connection thread
Air supply via push-in connector, angle, for 4 mm
tube,
outlet via push-in connector, angle, for 4 mm tube
Air supply via push-in connector, angle, for 6 mm
tube,
outlet via push-in connector, angle, for 6 mm tube
Air supply via push-in connector, angle, for 1/4"
mm tube,
outlet via push-in connector, angle, for 1/4" mm
tube
8 Option
Without
4–20 mA, actual value output
0–20 mA, actual value output
0–10 V, actual value output
9 Flow rate
15 l/min
GEMÜ 1434 µPos
Code 10 Travel sensor version
1434 Potentiometer, 10 mm length
Potentiometer, 30 mm length
Remote potentiometer,
Code
M12 connector
000
11 Type of design
Code
Standard
Z
Dead zone presetting 2%
Code
Dead zone presetting 5%
1
Inversed direction,
for quarter turn valves control function NO (2)
Code
A
12 CONEXO
B
Without
C
Integrated RFID chip for electronic identification
and traceability
Code
07
14
Code
1
2
3
U
Code
00
A0
B0
C0
Code
01
10 / 32
Code
010
030
S01
Code
2442
2443
6960
Code
C
www.gemu-group.com