Table of Contents
Advertisement
SYSTEM UPDATE (3/4)
Step 2: Plug in the USB memory stick
1.
Plug the USB memory stick into one of the USB inputs at the
back of the microscope or the Power box, depending on the
microscope model.
Step 3: Start installation
1.
The system update process is initiated in the Setup menu - Info
- System Update
A. Access the Setup menu by holding the round center
button on the XPLUS FHD control box until the Setup
menu appears
B. To navigate in the Setup menu, use the multi function
buttons on the XPLUS FHD control box
C. Go to the fourth menu point (Info) in the top menu,
navigate to System Update and choose it by pressing the
round center button
Step 4: Perform installation
Screen dialogues will now guide you through the update process
1.
A System Update Warning appears - Read the warning and
press OK to start the system update.
Note: At this point, the update process can be cancelled safely by
pressing Cancel.
NB: Do not switch off or disconnect the microscope during
a system update. This will damage your device and render
it useless.
2.
When the system update file has been read and validated,
information about the new version is shown. Wait for the
system to update.
3.
When the system update is complete, the microscope will
automatically restart.
Note: The microscope might switch off after restart. In that case,
turn it back on manually.
4.
After restarting the microscope, the system might need to be
updated again by following the same procedure as described
above entering system update
29
Advertisement
Table of Contents
