tagarno MOVE Manual page 12

OPERATION | XPLUS CONTROL BOX (2/5) OPERATION (1/2)
Control box XPLUS for TAGARNO functions.
Do only connect equipment distributed by TAGARNO.
Dimensions
H: 45mm/1.8" | W: 120mm/4.7" | D: 150mm/5.9".
On screen display (OSD)
The on-screen display provides you with the relevant information
when you push a button on the control box or Setup menu.
In this way you always know which function you are activating and
which parameters you are using.
Zoom
Push this button on the control box to zoom in.
Push this button on the control box to zoom out.
The magnification level will show via On Screen Display.
NB: It's also possible to zoom in/out by using Ctrl + the
plus or minus key on a keyboard.
Manual and Auto exposure mode
Open current exposure mode menu with key arrows up
and down in standard magnification mode or any active
application. Then, navigate the menu with arrows up and
down and adjust each setting with key arrows left and
right.
Switch between Manual and Auto exposure mode with a
short press to the round center button.
In Manual exposure mode, you can manually adjust the
iris, gain and exposure time with key arrows left and right.
Activate advanced camera settings in the microscope
camera settings to also enable contrast, saturation,
sharpness and noise reduction adjustment.
These settings will also be activated in Auto exposure mode.
Otherwise, exposure compensation is the only setting
visible. Iris, gain and exposure time will automatically be
adjusted to recommended settings and cannot be adjusted
in this mode.
Wait a few seconds for the menu to close and save your
settings.
Manual focus
Turn autofocus off by pushing both zoom buttons (plus
and minus) on the control box at the same time until you
hear a beep. You can now adjust focus manually with the
help of the zoom buttons.
Push this button on the control box to adjust focus if you
wish to focus on something very close.
Push this button on the control box to adjust focus if you
wish to focus on something that is farther away.
To turn the autofocus on again, simply push both zoom
buttons (plus and minus) at the same time until you hear
a beep. The focus values will show via On Screen Display.
NB: It is not possible to adjust Manual focus in the following
applications as they are reliant on the Ruler application: DXF
overlay, Particle analyzer, Speck counter, Color analyzer and
PNG reference.
12