Lincoln CORSAIR 2023 Owner's Manual page 54

Table of Contents

Advertisement

LATCH-compatible child restraints have two
rigid or webbing mounted attachments that
connect to the two lower anchors at the
LATCH-equipped seating positions in your
vehicle. This type of attachment method
eliminates the need to use seatbelts to attach
the child restraint.
However, you can still use the seatbelt to
attach the child restraint. For forward-facing
child restraints, you must also attach the top
tether strap to the proper top tether anchor
if a top tether strap has been provided with
your child restraint.
Follow the instructions on attaching child
restraints with tether straps.
2023 Corsair (CTF) Canada/United States of America, enUSA, Edition date: 202208, DOM
Child Safety
INSTALLING A CHILD RESTRAINT IN
A CENTER SEAT
WARNING: The standardized spacing
for LATCH lower anchors is 11 in (280 mm)
center to center. Do not use LATCH lower
anchors for the center seating position
unless the child restraint manufacturer's
instructions permit and specify using
anchors spaced at least as far apart as
those in this vehicle.
The lower anchors at the center of the
second row rear seat are spaced 18 in
(46 cm) apart. You cannot install a child
restraint with rigid LATCH attachments at the
center seating position. You can only use
LATCH compatible child restraints with
attachments on belt webbing at this seating
position provided that the child restraint
manufacturer's instructions permit use with
the anchor spacing stated. Do not attach a
child restraint to any lower anchor if an
adjacent child restraint is attached to that
anchor.
50
Each time you use the child restraint, check
that the seat is properly attached to the lower
anchors and tether anchor, if applicable. Tug
the child restraint from side to side and
forward and back where it is secured to your
vehicle. The seat should move less than 1 in
(2.5 cm).
If you did not properly anchor the child
restraint, the risk of a child being injured in
a crash greatly increases.
COMBINING THE SEATBELT AND
LOWER ANCHORS FOR ATTACHING
CHILD RESTRAINTS
When used in combination, you may attach
either the seatbelt or the LATCH lower
anchors first, provided a proper installation
is achieved. Attach the tether strap afterward,
if it is included with the child restraint.

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents