The Program Was Interrupted And A Fault Message Appears - Miele W1203 Operating And Installation Instructions

Frequently asked questions

The program was interrupted and a fault message appears.

Fault message
The buzzer sounds,
and the fault indicator
Drain flashes.
The buzzer sounds,
and the fault indicator
Intake flashes.
The buzzer sounds,
and the fault
indicators "Intake"
and "Drain" flash.
The buzzer sounds
and the "Status"
indicators "Soak" and
"Rinse" flash.
To turn off the fault message: Turn off the washer with the "On / Off" button.
30
Possible fault
The drain is blocked.
The drain hose is too
high.
The water inlet is
blocked.
The inlet hose filter is
clogged.
There is a fault.
There is a fault.
Solution
Clean the drain pump and lint
trap. See "Washer care -
Cleaning the drain pump and
lint trap".
The maximum drain pump
height is 4 ft (1.2 m).
Open the water valve.
Clean the filter under running
water and carefully remove
any large particles.
Call the Miele Service
Department.
Start the program one more
time. If the fault message
appears again call Miele's
Technical Service
Department.