The Program Was Interrupted And A Fault Message Appears - Miele W1213 Operating And Installation Instructions

The program was interrupted and a fault message appears.

Issue
The buzzer sounds, and
the "Drain" indicator
flashes.
"- - -". appears in the
display.
The buzzer sounds, and
the "Intake" indicator
flashes.
"- - -". appears in the
display.
The buzzer sounds, and
the "Intake" and "Drain"
indicators flash.
"- - -". appears in the
display.
The buzzer sounds and
the "Soak" and "Rinse"
indicators flash. "- - -".
appears in the display.
* To turn off the fault message: Turn off the washer using the "On / Off" button.
Frequently asked questions
Possible cause
The drain is blocked. Clean the drain pump and
The drain hose is too
high.
The water intake is
blocked.
The inlet hose filter is
dirty.
There is a fault.
There is a fault.
Solution*
lint trap. See "Cleaning and
Care - Cleaning the drain
pump and lint trap".
The maximum drain pump
height should not exceed
4 ft. (1.2 m).
Check to determine if:
– the water valve is open.
– the inlet hose is kinked.
Clean the filter under running
water and carefully remove
any large particles.
Call the Miele Service
Department.
Restart the program.
If the fault message appears
again, call Miele's Technical
Service Department.
31