•
Care must be taken by the installer to ensure that no electrical cables
or fuel lines are pinched or otherwise damaged during installation or
service.
Sharp edges can occur on, for example: fl ame tube, fan wheel and air
•
damper.
The gas outlet from the pressure regulator must be confi gured in
•
accordance with applicable regulations and lead to a safe area.
- before fi rst start:
The burner must not be put into operation without proper safety and
•
protection devices.
Permitted ambient temperature during operation -10 to +60 °C. Max.
•
80% relative humidity, no condensation.
The surface temperature of the burner's components may exceed
•
60 °C.
Handle with caution – the burner has moving parts, and there is risk
•
of crushing injuries.
Seal inspections must be performed during installation and servicing
•
to prevent leakage.
Fitting and installation work has been completed and approved.
•
Electrical installation has been correctly performed.
•
•
Flue gas ducts and combustion air ducts are not blocked.
•
All actuators and control and safety devices are in working order and
correctly set.
If the boiler is equipped with an access hatch, this must be equipped
•
with a hatch opening switch connected to the burner's safety system.
When in operation, the burner's noise level can exceed 85 dBA – use
•
hearing protection!
- Operation:
Carry out all stipulated settings, service and inspection work within
•
the set time.
1.3
What to do if you smell gas
Turn off the fuel supply.
•
Turn off the device and remove the boiler from operation.
•
Open windows and doors.
•
Prevent open fl ames or sparking, e.g. do not turn lights on or off, do
•
not use any electrical appliances or mobile phones.
•
Evacuate the building.
Notify the installer or gas supplier of the problem so that it can be
•
rectifi ed.
5
Bentone