Advertisement
2 SETUP
4
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
–
Remove the separate enclosure and unpack it. Check the sepa-
rate enclosure for completeness.
A00043-10
Info
The procedure in the event of missing components is
described in the customer service manual.
–
Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the customer service manual.
Condition
Left and right handlebar stub not mounted.
–
Remove protective film on the left and right handlebar
stub.
–
Mount left and right handlebar stub on the upper triple
clamp.
Info
Make sure the cables and wiring are positioned cor-
S01885-10
rectly.
–
Mount and tighten screws
Guideline
Screw, handle-
bar stub
–
Mount and tighten screws
Guideline
Screw, anti-rotation
lock, handlebar
stub
–
Position the clutch and hand brake assembly on the han-
dlebar stubs, mount the clamp screws and tighten.
–
Attach the clutch cable to the clutch lever and slide on the
protection cap.
–
Connect the cable of the brake light switch to the hand
brake assembly.
1
.
M6
8 Nm (5.9 lbf ft)
Loctite
2
.
M5
4 Nm (3 lbf ft)
®
243™
Advertisement
