Timer Function - Zephir ZMW4000V Instruction Manual

Get two holes on the wall 2 m above the floor and near the corner more 25 mm, be sure to make the
diameter just as same as the expanding pipe. Fix two screws on the expanding pipe, keep the tips of
the screws out for 10mm, and hang up the machine after the screws are fixed enough.
330
OPERATION INSTRUCTION
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on a firm level surface ,setting the master button to "-"position.plug the cord set into
a AC220-240V electrical outlet,with "BEE" sounds the "Power"light is on and the heater will shows
the room temperature.
1.Set time
WEEK Press "Set" button again, "Mo"light twinkle ,press "
Su (Mo=Monday...Su=Sunday ect.)
HOUR Press "Set" button one time,LED display front "00" twinkle, press "
the Hours from 01--00(01=1 o'clock,02=2 o'clock...00=24 o'clock ect.)
MINUTE Press "Set" button again,LED display behind "00" twinkle, press "
the minutes from 00--59(01=1 Minute,02=2 Minute ect.)
2)General Using OPERATION
4. Turn the heater ON by pressing remote control the ON/OFF button ,the unit will blow the cold air .
5. Pressing the "MODE" button on remote control ,the unit will blow the warm air and
on.
6. Pressing the "MODE" button second times on remote control,the unit will blow the hot air and the
will light on
4.Pressing the "MODE" button Three times on remote control,the unit will blow the cold air
5. Pressing the "Swing" button,the heater will be
PS:For smart operate,customer only press the one start button near about master
button,the heater will working with hot air and Swing function.
3) 24H Timer FUNCTION
two buttons set the week from Mo--
swing the blade up and down
two buttons set
two buttons set
will light