Getting Started; Vi.1 Charging The Nimh Battery Pack; Vi.2 Attaching And Removing The Battery Pack - Midland PL-5161 Operating Instructions Manual

I.1.1.1 pro
Hide thumbs Also See for PL-5161:
Table of Contents

Advertisement

VI

GETTING STARTED

VI.1
CHARGING THE NIMH BATTERY PACK
You will need to charge the battery pack fully before initial use. For best results from your charging cycle, follow
these tips:
Ensure the ambient temperature is between 41 and 104° F (5 and 40° C) while charging. Temperatures
outside this range may not fully charge the battery.
Always switch OFF the transceiver equipped with a NiMH battery pack before charging. Using the radio
during the charging cycle will hinder correct charging.
Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery
pack to shorten or the battery pack may be damaged.
If the battery is stored for 2 months or more, it is a good idea to complete the charge / discharge cycle two
or three times to allow the battery capacity to return to normal.
Never dispose of the battery in fire - it can explode causing personal injury.
Never attempt to disassemble the battery or remove its case material or charging contacts. Do not short the
battery terminals.
NOTE: The first few uses from the battery will not be at "normal" capacity. After repeating the charge /
discharge cycle two or three times, the battery capacity will increase to provide full capacity.
1. Plug the AC adapter cable in the adapter jack located on the rear of the charger, then into an AC outlet.
2. Slide the NiMH battery pack (or the radio equipped with a NiMH battery pack) into the charging slot.
3. Ensure that the metal contacts on the battery pack come in contact with the charging terminals.
4. When charging the NiMH battery pack alone, insert the provided plastic spacer (stored in charger base)
into the charging well, then insert the battery pack.
5. The charger LED will light to advise that charging has begun. Charge the standard battery pack for
9 hours. THEN REMOVE THE PACK OR RADIO FROM THE CHARGER.
IMPORTANT NOTE: The ACC-410 SLOW charger DOES NOT TURN OFF AUTOMATICALLY after
the charging cycle has been completed. Damage to the battery or reduced battery life may result if charged in
excess of the recommended charging time.
VI.2
ATTACHING AND REMOVING THE BATTERY PACK
NOTE: After recharging the battery pack, REMOVE IT FROM THE CHARGER. Charging the battery pack for
more than 5 days may reduce the battery life.
The battery pack life is over when its operating time decreases even though it is fully and correctly charged. Replace
the pack with the manufacturer's recommended model.
Average battery pack life from the supplied 750 mAh battery is 8+ hours; the optional 1350 mAh battery, 10+ hours.
This service time is calculated using 90% standby, 5% transmit and 5% receive time and 5W operation.
After charging the battery pack as described, you are ready to install it to the radio body. Simply;
1. Match the four grooves of the battery pack with the guides on the back of the radio.
2. Slide the battery pack up along the back of the radio until the release latch locks.
To remove the battery pack, push down on the release latch and slide the pack downward, and away from the
radio.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pl5164

Table of Contents