Table of Contents
Advertisement
XN300 switch XN-332-5ETH-UMS
Proper use
The XN300 switch XN-332-5ETH-UMS is an integral part
of the XN300 system. It can be used to connect multiple
network segments with its five ports and have the data
packets coming into one of five Ethernet ports (X1–X5)
be distributed to the other ports.
Power supply and signal terminals must be protected
against accidental contact and covered.
The XN300 system may only be operated if it has been
correctly fitted and connected by qualified electrical
specialists. The installation must comply with regulations for
electromagnetic compatibility (EMC).
COMMISSIONING THE XN300 SYSTEM DEVICES AND SWITCHING
THEM ON MUST NOT RESULT IN ANY HAZARDS BEING POSED
BY THE DEVICES BEING DRIVEN, E.G., UNEXPECTED MOTOR
STARTUPS AND EQUIPMENT BECOMING UNEXPECTEDLY
ENERGIZED.
Overview of functions
The XN-332-5ETH-UMS XN300 switch features the same
design as the other devices in the XN300 system.
The aforementioned XN300 system includes XN300 slice
modules in the form of I/O modules and speciality modules,
as well as gateways such as the XN-312-GW-CAN and
XN-312-GW-EC.
The XN-332-5ETH-UMS is an unmanaged switch without
a system bus and is accordingly snapped onto the top hat
DIN rail as a standalone device.
DO NOT ATTEMPT TO INSTALL THE XN-332-5ETH-UMS WITHIN AN
XN300 SYSTEM BLOCK.
Power is provided via a 24 Vdc power input at the top
of the device.
DANGER
NOTICE
Versions
The XN300 switch is housed in a double-width case. Power
is supplied from above through a 4-pin FMC 1.5/4-ST-3.5
connector.
Figure 1 . XN-332-5ETH-UMS front view
RN
DC
LA
X1
FD
LA
X2
FD
LA
X3
FD
LA
X4
FD
LA
X5
FD
InstructIon manual MN050011EN August 2022 www.eaton.com
XN300 switch XN-332-5ETH-UMS
LED RN
LED DC
X1
LED LA
LED FD
ETH1
X2
XLED LA
LED FD
ETH2
X3
LED LA
LED FD
ETH3
X4
LED LA
LED FD
ETH4
X5
LED LA
LED FD
EHT5
X6
POW
1
Advertisement
Table of Contents
