Installation; Mounting The Switch; Wiring Requirements - Eaton TRIPP LITE Series Quick Start Manual

Installation

Instalación / Installation /
Installation / Installazione

Mounting the Switch

Instalación del Switch
Montage du commutateur Démontage du commutateur
Montage des Switches
Montare l'interruttore
Mounting the Switch
Place the switch on the DIN rail from above using the slot, then push the front of the switch
toward the mounting surface until it snaps into place with a click sound.
Dismounting the Switch
Press the switch from top and pull out the lower edge of the switch, then remove the switch
from the DIN rail.
ATTENTION: Use of a corrosion-free mounting rail is advisable. When installing, make sure to
allow enough space to properly install the cabling and allow ample airflow.

Wiring Requirements

WARNING: Safety measures should be taken before connecting the power cable. Turn off the
power before connecting modules or wires. The correct power supply voltage is listed on the
product label. Check the voltage of your power source to make sure you are using the correct
voltage. DO NOT use a voltage greater than what is specified on the product label. Calculate
the maximum possible current in each power wire and common wire. Observe all electrical
codes dictating the maximum current allowable for each wire size. If current exceeds the
maximum rating, the wiring can overheat causing serious damage to your equipment.
2
Removing the Switch
Retiro del Switch
Ausbau des Switches
Smontare l'interruttore