acaia AL010 User Manual page 18

Auto-Tare Mode
The default setting is On.
• On: Mode enabled.
• Off: Mode disabled.
Flow-Rate Indicator Setting [ FLorAtE.d ]
1. This is automatically set to Default.
2. Default: Flow-Rate Indicator enabled. The Flow-Rate Indicator on the top of the display turns
on and visualizes your espresso flow-rate in real time.
3. Grad: Flow-Rate Indicator and Flow-Rate Markers enabled. The markers will turn on when
brewing. Every marker represents a 0.5g/s increment in flow-rate.
4. Off: Flow-Rate Indicator disabled.
Average Flow-Rate Setting [ Avg.FLo ]
1. The default setting is On.
2. On: Average Flow-Rate enabled. When brewing is complete and the cup is removed from the
scale, the display will show the espresso summary with the beverage weight and the average
flow-rate of brewing.
3. Off: Average Flow-Rate disabled. When brewing is complete and the cup is removed, the
display will show the espresso summary with the beverage weight and the current weight.
Weight Stable Indicator Setting [ StAbLE.d ]
1. The default setting is Off.
2. On: Weight Stable Indicator enabled. The Weight Stable Indicator on the bottom left of the
display lights up when the weight is stable.
3. Off: Weight Stable Indicator disabled.
Auto-Reset Setting [ Auto_rES ]
1. After a cup is removed, the timer and weight will automatically reset. This setting gives you
options on how long to wait for the reset. It enables the user to pull successive shots of
espresso quickly in the three Auto-Start modes.
2. The number indicates the timeout value in seconds of timer reset after a cup is removed.
Pre-Infusion Time Out Setting [ PrE_inFu ]
1. Determines when the scale times out in Auto-Start
when the timer is manually started. This is most useful for long pre-infusion times and resolves
the timeout issue that sometimes happens for slower pre-infusions.
2. The number indicates the time in seconds it will take for the scale to reset if no espresso flow
or weight is detected.
Auto-Start Sensitivity Setting [ SEnSE ]
1. Minimum weight is decreased for more sensitivity. This is ideal for slower espresso shots in the
modes. Stability depends on environmental noise.
2. The number indicates the sensitivity of flow detection in the
indicates higher sensitivity, but is recommended only for stable working environments.
Setting [ NodE_6 ]
mode and two Auto-Start
modes. A smaller value
modes
18