Advertisement
RSV4 Factory a-PRC
Head cover removal
•
Unscrew and remove the three screws
with rubber washers.
•
Remove the head cover together with
the sealing gasket.
INSTALLATION
•
Install a new gasket in the head cover.
•
Smear the gasket with suitable seal-
ant, in the area indicated in the figure.
Recommended products
Three bond Sealing paste
-
•
Smear the head surface with suitable
sealant, in the area indicated in the fig-
ure.
Recommended products
Three bond Sealing paste
-
•
Fit the head cover.
•
Tighten the three screws with rubber washers to the prescribed tightening torque.
Front head
Engine
ENG - 307
Advertisement
