Taking A Measurement - A&D UC-352BLE Instruction Manual

Taking a Measurement

Step On
1. Confirm that the scale is turned off, and step on the
scale gently.
• Measurement starts when you step on the scale.
• A progress bar is displayed during measurement.
Stand up straight and remain as still as possible
during measurement.
2. Step off the scale when "StEP" and "oFF" are
alternately displayed with three beeps.
• If you do not step off, the scale beeps every two
seconds.
• The scale turns off automatically after 2 minutes.
• All display segments are indicated when you step
off the scale.
• Do not touch the scale while all display segments
are displayed. It may cause misreading.
3. Confirm the measurement results.
• The scale turns off automatically 60 seconds after
the measurement results are displayed.
• Data is automatically sent to the receiver if the
receiver is in the receivable state.
• If the scale is not paired with a receiver, the data
is stored in the scale memory. (See "Transmitting
Temporarily Stored Data".)
• Data stored in the scale memory cannot be viewed
on this scale.
• You can also shut the power off by pressing the set switch.
• The most recent readings will be shown on the screen.
E-11
Beep
Beep beep beep
+ -
lb
k g
lb