Section 1: Disassembly - PAC CH1AJKIT Manual

CH1AJKIT
Vehicle Integration Upgrade Kit for
SR-JK11H / Stinger HEIGH10
®
2011-2018 Jeep Wrangler JK
®

Section 1: Disassembly

Step 3
Step 1 Step 2
Once the side clips are
Using a very thin pry tool or
Remove the front frame by first
disengaged, swing the bottom
similar, carefully release the side
releasing the side clips at the
edge upwards to unhook the top
clips as shown on both sides.
locations indicated by arrows.
of the frame and remove.
Step 5
Step 4
While holding the display with
Using a magnetic Phillips
one hand, insert a soft plastic
screwdriver, remove the two
panel tool under either bottom
mounting screws on the left and
corner and slightly pry up to
right sides of the mounting panel.
release the display panel.
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Rev: V1
®
Page 3
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms Date:102622
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation