Reversible Access Door; Configurable Access Door - Hatco MDW Series Installation And Operating Manual

Reversible Access Door

access door(s) may be hinged on either the left or right side for
convenience. Use the following procedure to reverse the access
door.
1. Remove the top hinge pin screw that secures the door to
the door bracket and save.
2. Carefully lift the door off of the bottom hinge pin. also
remove the nylon washer from the hinge pin and save.
3. Remove the screws holding the door bracket to the unit.
4. Remove the screws holding the glass bracket to the unit.
5. Install the glass bracket on the side of the cabinet where
the door bracket was mounted previously.
6. Install the door bracket on the side of the cabinet where
the glass bracket was mounted previously.
7. Move the hinge cap on the bottom of the door bracket from
what is now the inner hinge pin to the outer hinge pin.
8. Place the nylon washer over the inner hinge pin.
9. Carefully rotate the door 180° and place the door assembly
onto the inner hinge pin (make sure the nylon washer is in
place).
10. Tip/tilt the door assembly towards the cabinet and align the
top of the door with the top hinge. Install the top hinge pin
screw through the hinge and into the door. Tighten
securely.
Bottom of Door Bracket
(mounted on left side of opening)
Hinge
Nylon
Cap
Washer
Inner
Outer
Pin Pin
Form No. MDWCEM-0411
Screw
Door
Bracket
Figure 6. Reversible access Door and Fixed Glass Panel
7

Configurable Access Door

a door can be exchanged with any glass panel to suit the
installation site.
1. Remove the door assembly and the door bracket.
a. Remove the top hinge pin screw that secures the door
to the door bracket and save.
b. Carefully lift the door off of the bottom hinge pin. also
remove the nylon washer from the hinge pin and save.
c. Remove the screws holding the door bracket to unit.
2. Remove the glass panel and the glass bracket.
NOTE: Make sure to remove only the glass bracket that will be
replaced with the door bracket (the side that the door
hinge will be located on).
a. While holding the glass panel securely, remove the
screws holding the glass bracket to the unit. Keep
hardware.
b. Carefully lift the glass panel off the unit and set in a safe
place.
3. Install the door assembly and the door bracket.
a. Make sure the hinge cap on the bottom of the door
bracket is installed on the outer hinge pin.
b. Place the nylon washer over the inner hinge pin.
c. Place the door assembly onto the inner hinge pin (make
sure the nylon washer is in place).
d. Tip/tilt the door assembly towards the cabinet and align
the top of the door with the top hinge. Install the top
hinge pin screw through the hinge and into the door.
Tighten securely.
4. Slide the glass panel into the groove of the installed glass
bracket.
5. While holding the glass panel securely, install the
remaining glass bracket to the unit to secure the glass
panel in place.
Hinge
Pin
INSTALLATION
Screw
Glass
Bracket