JUKI AKANE MO-3000QVP Instruction Manual page 27

Threading 4/3 Thread OL
2
3
1
4
5
■ Another method of threading the loopers
It is also possible to automatically thread the loopers even
if you transpose the aforementioned steps (7) and (8).
Leave the air-control switch placed in ON and bring the tip
of the thread close to the threading hole. Then, the thread
will be sucked into the threading hole and the loopers will
be threaded.
1. Place the air-control switch in ON.
2. Bring the tip of the thread close to the threading hole.
* At this time, pinch the tip of the thread short.
3. The thread is sucked into the threading hole.
4. The loopers are threaded.
5. Turn OFF the air-control switch.
26