Table of Contents
Advertisement
Model SKFI18
The Model SKFI18 has a stainless steel exterior that has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm,
mild soapy water solution and a sponge or cloth. The Model SKFI18 has louvered panels at the bottom front and rear of the cabinet.
When installing the unit, these areas require a minimum spacing of six (6) inches to allow proper airflow to the condensing unit and to
maintain the compressor warranty!
Model SKEDI18
The Model SKFDI18 is designed to drop into a counter or bar for convenient serving. A square cutout of 16.75 inches by 16.75 inches is
required to drop the cabinet into the countertop. The counter must be able to support a weight of at least 150 pounds or the unit should
be supported from the bottom. Once installed into the countertop a bead of silicone should be placed around the perimeter of the top to
prevent moisture from seeping through. When installing the unit into a countertop it is extremely important to provide adequate air
circulation to the condensing unit to maintain the compressor warranty! If the cabinetry is not vented to allow the warm condensing unit
discharge air to escape, you will need to provide holes in it for that purpose. The suggested method for venting is to cut 8.5 inch square
holes in the counter directly in front of the condenser and directly behind the compressor. Once installed the interior and the exposed
exterior surfaces should be washed using a warm, mild soapy water solution and a sponge or cloth.
LOCATION
When locating your countertop drop-in display merchandiser, convenience and accessibility are important considerations, but the
following installation guidelines must be followed;
•
For SKFDI18, when installed in a countertop, provisions need to be in place for the unit to receive proper ventilation for the
compressor. Do not install the unit in cabinetry that does not have provisions for ventilation as that would void all warranties.
•
Always avoid placing the unit next to an oven, heating element or hot air source that would affect the operation of the unit.
•
The unit must be level.
•
For SKEDI18 the counter must be able to support a minimum of 150 pounds.
•
See installation diagram on the next page.
Safety
Do not store explosive substances such as aerosol cans with a flammable propellant inside the appliance.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate
the manufacturers responsibility, and could result in serious injury.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard."
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
Energy Rating
Your Silver King refrigerator has a class 5 energy rating. The refrigerator was tested at an ambient temperature of 40°C at 40% relative
humidity.
4
Advertisement
Table of Contents
