History Data - Victron energy BMV-710H Smart Manual

• Press SELECT again to stop scrolling and show the value.
• Press SELECT again to leave the historical menu and to go back to the normal operation mode.
The below table gives an overview of the history parameters and how they are displayed in the menu. For the meaning of each
parameter see the next chapter.
#
A
B
C
D
E
F
G
H
I
J
L
M
R
S

5.5.3. History data

Discharge information in Ah
• Deepest discharge: The battery monitor remembers the deepest discharge and each time the battery is discharged deeper
the old value will be overwritten.
• Last discharge: The battery monitor keeps track of the discharge during the current cycle and displays the largest value
recorded for Ah consumed since the last synchronisation.
• Average discharge: The cumulative Ah drawn divided by the total number of cycles.
• Cumulative Ah drawn: The cumulative number of Amp hours drawn from the battery over the lifetime of the battery monitor.
Energy in kWh
• Discharged energy: This is the total amount of energy drawn from the battery in kWh.
• Charged energy: The total amount of energy absorbed by the battery in kWh.
Charge
• Total charge cycles: The number of charge cycles over the lifetime of the battery monitor. A charge cycle is counted every
time the state of charge drops below 65% and then rises above 90%.
• Time since last full charge: The number of days since the last full charge.
• Synchronisations: The number of automatic synchronisations. A synchronisation is counted every time the state of charge
drops below 90% before a synchronisation occurs.
Page 18
Manual - BMV-710H Smart
Display Discription
Deepest discharge
Last discharge
Average discharge
Cycles
Discharges
Cumulative Ah
Lowest voltage
Highest voltage
Days since last discharge
Synchronisations
Low voltage alarms
High voltage alarms
Discharged energy
Charged energy
Operation